RM新时代国际足球交易平台

　　1. Before spraying and processing hardware products, the spraying factory needs to clean up the spraying address. Impurities are not allowed to appear in the process of spraying, and the surface of products should be kept intact and clean.

　　2. In the process of spraying, only hardware

　　The surface should be decorated with one layer, and it is not allowed to spray too thick.

This will lead to paint too thick, color deformation phenomenon, which is not conducive to the normal use.

　　3. The uniformity of the paint should be ensured during spraying, and the paint should be mixed before spraying, so that the paint can be fully combined, and the upper layer of the paint will not be lighter and the lower part will be turbid.

　　4. In the process of spraying, if the paint is too viscous, additives can be used in the spraying process. The spraying plant should distribute the paint according to the relevant proportion, and the imbalance of proportion is not allowed.

　　5. Pay attention to the spraying process to ensure the satisfactory and even spraying. The phenomenon of different thickness is not allowed. For the paint with different thickness, the overall aesthetics will be affected after spraying, which will cause visual disharmony.

　　Article origin: Jiangmen spraying processing factory